Week 3 Checkpoint – Industry Technical Skills

Which specific tool is used to ensure that bolts are tightened to the exact manufacturer’s specifications to prevent misalignment or equipment wear?

A mechatronics technician needs to ‘see’ the invisible condition of a circuit to diagnose a proximity sensor failure. Which tool should they use?

In Advanced Manufacturing, ‘Metrology’ is defined as:

A blueprint shows a required part size of 25.00 mm with a tolerance of ± 0.02 mm. Which of the following actual measurements would be considered ‘Scrap’?

What happens to the total resistance (Rₜ) in a Parallel Circuit as you add more paths for the current?

Using Ohm’s Law (V = I x R), if a technician measures a solenoid coil with 10 Ω of resistance on a 24 Volt DC line, what is the expected current (I)?

A technician measures a component and finds the current is zero, despite the system being turned on. According to the lesson, this fault is called:

Which set of ‘Starter Kit Essentials’ is most focused on diagnosing sensors, PLCs, and using wire strippers?